816-842-1777

2235 Taney St.
North Kansas City, MO 64116

 
Acura Audi Chrysler Ford GM Honda Hyundai Jeep Kia Lexus Mazda Mitsubishi Nissan Saab Saturn Subaru Toyota VW Volvo | Fleet and Hybrid
TIRE STORE BRANDS: Michelin BFGoodrich Uniroyal

AutoNetTV


Keep Your Cool In North Kansas City

Posted September 20, 2012 9:40 AM

/> Your browser does not support video

North Kansas City drivers rely on their car's coolant system to keep their engine cool. Coolant (also called antifreeze) mixed with water flows through your SUV engine and absorbs heat. The mixture then flows out to the radiator where it’s cooled by air flowing over the radiator. From there the coolant/water mix circulates back through the engine to absorb more heat.

There’s a reason we mix coolant and water. Water alone actually does a good job transferring heat from the engine. The problem is that water boils at a temperature that’s easily reached inside your SUV's engine, so it can turn to steam which does not conduct heat as well and is harder to contain.

Also, if it’s freezing outside in North Kansas City, the water in your engine could freeze while your vehicle is sitting out in the cold.

So, if you remember your North Kansas City high school chemistry, you’ll know that a mixture has both a higher boiling point and a lower freezing point than either component alone.

Coolant, or antifreeze, is specially formulated to keep your engine safe in a wide range of environmental and operating temperatures in and around North Kansas City.

Keep Your Cool In North Kansas City Whenever the SUV is running, the coolant in the cooling system is working to keep your engine from overheating. When it’s cold outside, the coolant acts as antifreeze to keep the fluid from freezing in your engine.

All that exploding fuel in your engine creates a lot of heat. Without coolant, the metal SUV engine parts would expand so much that the engine would seize up and stop running. Expensive parts could be broken or warp so badly they would have to be replaced. It could even be so bad that the whole SUV's engine is ruined and has to be junked.

This is why it is critical that North Kansas City drivers check coolant levels frequently and have their SUV cooling system inspected for leaks. Also your SUV manufacturer has a maintenance requirement for draining and replacing your coolant. These recommendations can vary widely, so check your owner’s manual or ask us at Northtown Auto Clinic in North Kansas City.

The reason you need to change the coolant is that it has additives in it to protect the cooling system. As you can imagine, with all the heat, the cooling system’s a pretty harsh environment. The additives keep the fluid from becoming corrosive and damaging the radiator and other SUV cooling system components. Over time, the additives are depleted and the coolant just has to be replaced.

Many North Kansas City auto owners ask Northtown Auto Clinic why there are different colors of antifreeze. It is very important that you use the correct type of antifreeze. The different types of antifreeze – or coolant – are different colors so you don’t mix them up.

Auto manufacturers use different materials to make the cooling system, and they require different types of antifreeze to protect them.

So check with us at Northtown Auto Clinic or your owner’s manual for the right kind because using the wrong coolant can void the warranty for your SUV cooling system.


Posted in the Cooling System category


Water Pump

Posted June 16, 2012 10:41 AM



Your cooling system is very important. It circulates coolant through the radiator and your engine to protect your car from overheating. There are five main components to the cooling system:

  • the radiator
  • the radiator cap
  • the hoses
  • the thermostat and
  • the water pump

The water pump’s like the heart of your cooling system, circulating the fluid throughout. It’s a small pump that’s driven by the engine; usually by belt, but sometimes by a chain or gear.

The water pump only operates when the engine’s running. Water pump failure is pretty routine. Some start failing at around 40,000 miles, but most fail by 100,000 miles. Consult your owners’ manual or service technician to see what’s recommended.

Since a water pump either works or it doesn’t, you need to change it when it fails. Water pumps fail in one of two ways: the bearings fail or they begin to leak. It’s possible to have a leak from a cracked water pump, but it usually leaks at the gasket where it attaches to the engine.

So how can you tell when the water pump is failing? If you can hear a low-pitched grinding sound coming from the water pump – it’s got a problem. If you can see coolant in that area, you’ve got a leak.

Some water pumps are driven off the timing belt. They might be under a plastic cover so you can’t see the water pump. Look for coolant on the driveway. If you see some, have your service center check it out.

Most timing belts need to be changed at 60,000 miles – some longer. It’s a good idea to change your water pump at the same time if it’s one of those that’s driven off the timing belt. To start with, 90% of the work’s already done with the timing belt change. And, if you don’t, and develop a leak later, you’ll have to change the belt again along with the water pump because the belt will have been contaminated by the leaking coolant.

You can replace your water pump with a brand spankin’ new one or with a rebuilt pump. Rebuilt will save you some money, but ask your technician what he thinks. Don’t feel too bad if your water pump gives out. They will all wear out eventually. Your service technician can get you back on the road and on with your life.


Posted in the Cooling System category


Cooling System Components

Posted May 19, 2012 11:51 AM



Today we want to talk about a very important system in our cars – the cooling system. It’s one of those things that you don’t give much thought to until it fails and then you’re stranded by the side of the road.

Cooling systems fail more often than any other mechanical system – usually because of neglect. Don’t you hate it when something breaks, and you could have done something to prevent it?

The good news is that if you take care of your cooling system it can keep working for the life of your car.

Here at AutoNetTV, we emphasize preventive maintenance services like replacing your coolant according to the factory schedule. But the various parts that make up the cooling system need attention too. The major components of the cooling system are the water pump, freeze plugs, the thermostat, the radiator, cooling fans, the heater core, the pressure cap, the overflow tank and the hoses.

It sounds complicated, but we don’t have to be experts – we can leave that to our friendly service technicians at Northtown Auto Clinic. But, having an overview will help us remember to take care of our cooling systems.

Most people would be surprised to know that burning fuel in your engine produces up to 4,500 degrees of heat. And all that heat has to be dealt with. If the heat can’t be drawn off the engine, the pistons will literally weld themselves to the inside of the cylinders – then you just have to throw the engine away and get a new one. That would cost thousands of dollars.

Now the water pump is what forces the coolant through passages in the engine to absorb heat. The pump is driven by a belt that needs replacement from time to time. And the water pump will eventually wear out and need to be replaced. Spending some money on replacing the belts and water pump is much less than the cost of repairing the massive damage that can be done when an engine seizes.

There’s another little part of the coolant system that protects the engine. It’s called a freeze plug. If you remember from high school chemistry, water expands when it freezes. In very cold areas, the coolant can actually freeze when the vehicle is left sitting.

It is hard to believe, but the expanding frozen coolant can actually crack the engine block. The freeze plugs fit into the engine block. They fit tight enough to withstand the pressure of a running engine, but can expand or pop out if the coolant freezes. These little things save a lot of engine blocks.

That brings up a good point. An engine has to work in all kinds of temperatures – extremely hot as well as very cold. How does the cooling system adapt to external temperatures as well as varying operating conditions?

Well, it’s much like the way you keep your house at a comfortable temperature all year round – with a thermostat. The thermostat in your car controls how much coolant flows through your engine. When the engine is cold, it restricts coolant flow until the engine comes up to an efficient operating temperature. Then it starts opening up to move more coolant to keep the temperature within a specified range.

The thermostat needs to be replaced from time to time as well. It’s easy to diagnose a failed thermostat and is fairly inexpensive to replace. We can do this for you at Northtown Auto Clinic in North Kansas City, just give us a call: 816-842-1777. Now we’ve been talking about all this heat we’ve got to get rid of, but haven’t really talked about where it goes. That’s where the radiator comes in. The hot coolant passes through the radiator. Air flows past the cooling fins and cools the coolant.

The radiator has two tanks that hold coolant: sometimes one the top and bottom or one on either side. If you have an automatic transmission, one of the tanks will also contain a second tank that cools the transmission fluid. Large SUV’s and trucks often have a separate transmission cooler. So when you drive around North Kansas City, the air is forced past the radiator. But driving doesn’t produce enough air flow. So the radiator has cooling fans that force fresh air over the radiator. These fans may be powered by a belt or by electric motors.

Now, you also have something called a heater core. The heater core is like a mini radiator. A small fan blows air over the heater core and into the passenger compartment of your vehicle. That’s how you warm your car when it’s cold out.

Next is the radiator cap. With most newer cars around North Kansas City, you never remove the radiator cap, except to replace it. You add coolant through the overflow tank. The radiator cap is also called a pressure cap, because its job is to maintain pressure in the cooling system.

High pressure raises the boiling point of the coolant, so it cools more effectively even in very demanding conditions. That is why you need to replace the cap from time to time. They recommend changing it out every time you replace your coolant.

Coming back to the overflow tank, it is needed because when the coolant gets hot it expands and the overflow holds the extra volume. The tank helps maintain the proper level of coolant and keeps air out of the system. You should never open the radiator cap or over flow tank when the engine is hot. This could lead to serious burns.

What else do we need to do to keep our cooling systems working well? Well, there are the hoses that hook all of these pieces together. They’re obviously very tough to deal with the pressure and high temperatures. But they do get worn. Sometimes they get spongy from the heat. Sometimes they lose their connection to the radiator, water pump, etc. It’s a great idea to have your North Kansas City service center inspect your hoses at least once a year and replace them, if needed, before they break.

Northtown Auto Clinic can help you check your cooling system and make any necessary adjustments or repairs. Give us a call at 816-842-1777.


Posted in the Cooling System category


Radiator Service

Posted March 25, 2011 8:57 PM



The coolant system is a vital part of your vehicle. It is also the second most common cause for vehicle failures. Even though coolant system failure is fairly common, it is easy to prevent.

The most recognizable part of the coolant system is the radiator. It is connected to the engine with hoses and is filled with coolant. The coolant draws heat off the engine and then goes into the radiator. Air passes through cooling fins to reduce the temperature of the coolant and then it's back to the engine again.

There are several ways for the cooling system to fail. Most common is with the coolant itself. Coolant is a mixture of water and antifreeze. The proper mixture keeps the coolant from either boiling away or freezing. Both of which can result in massive engine damage.

Another very important coolant issue that is often overlooked is the age of the coolant itself. antifreeze has additives that protect the coolant system from corrosion. As these additives are depleted over time, they can't protect the radiator and other parts from rust, scaling and corrosion. Old coolant may still keep your engine cool, but it won't protect it from corrosion.

If you see a warning message to check the coolant or if the temperature gauge is in the hot zone your cooling system needs to be checked. It's OK to add water or antifreeze yourself. But you need to be cautious. Remember four things.

  • First, you never want to open the radiator pressure cap. You could be severely burned.
  • Second, try to get to a North Kansas City service center such as Northtown Auto Clinic immediately if your coolant is low. If that is not possible, follow the directions in your owners manual - it will direct you to only make additions to the coolant overflow bottle.
  • Third, remember that you need a proper mixture of water and antifreeze. If you make an emergency addition to your cooling system, follow-up with your service center where they can make necessary corrections.
  • Fourth, not all cars use the same type of antifreeze. You need to check your owners manual to make sure you use the right kind. Mixing antifreeze types or using the wrong kind of antifreeze may void the manufacturers warranty on your cooling system. Again, another reason to rely on your North Kansas City service center to do things right.

Remember, Northtown Auto Clinic has the equipment to change your coolant quickly and inexpensively. 816-842-1777


Posted in the Cooling System category



Search


Archive

March 2011 (16)
April 2011 (5)
May 2011 (4)
June 2011 (4)
July 2011 (5)
August 2011 (4)
September 2011 (5)
October 2011 (4)
November 2011 (4)
December 2011 (5)
January 2012 (4)
February 2012 (5)
March 2012 (4)
April 2012 (4)
May 2012 (5)
June 2012 (4)
July 2012 (4)
August 2012 (5)
September 2012 (4)
October 2012 (5)
November 2012 (4)
December 2012 (4)
January 2013 (5)
February 2013 (3)
March 2013 (5)
April 2013 (4)
May 2013 (5)
June 2013 (2)

Categories

Air Conditioning (4)
Alignment (6)
Automotive News (2)
Battery (1)
Brakes (3)
Cabin Air Filter (2)
Cooling System (4)
Dashboard (1)
Drive Train (3)
Exhaust (1)
Fluids (5)
Fuel System (21)
Inspection (1)
Maintenance (26)
Monitoring System (1)
Older Vehicles (2)
Parts (7)
Service Intervals (3)
Service Standards (8)
Shocks & Struts (3)
Steering (3)
Timing Belt (1)
Tires and Wheels (17)
Transmission (3)
Warranty (2)
Windshield Wipers (2)

back to top

Contact Information

Northtown Auto Clinic
2235 Taney St.
North Kansas City, MO 64116

Phone: 816-842-1777
Email: service@northtownautoclinic.com
 
Hours of Operation

Monday - Friday 7:30AM - 5:30PM
Saturday & Sunday CLOSED

Holidays
Days recognized as holidays that Northtown Auto Clinic will be closed:

New Years Day, Forth of July, Labor Day, Thanksgiving, & Christmas 

 

Schedule
An Appointment

Get Started

 


816-436-8811

 
Auto Service Repair Tips
 
Preventive Maintenance

Does Preventive Maintenance Really Pay?
Find out by viewing our detailed diagram on the importance of preventive maintenance.

View preventive maintenance diagram

 
Payment Options

At Northtown Auto Clinic we offer several different payment options as we know auto repairs can sometimes be unexpected.

Cash, Approved Check